Quipall 2000EPW - Troubleshooting; Repairs

10
Symptom
Cause
Recommended action
The machine will not
start
The machine is not plugged-in
Plug the machine in
Faulty receptacle
Try another receptacle
The fuse has blown
Replace the fuse Unplug other appliances
Faulty extension cable
Try without the extension cable
Fluctuating pressure
The pump is drawing in air
Check that hoses and connections are airtight.
Valves dirty, worn or sticking
Contact your service center
The water supply is not
sufficient
Increase water pressure, check for blockages
and / or change the large pipe.
Pump seals worn
Contact your nearest service center
The machine stops
The fuse has blown
Replace the fuse
Incorrect mains voltage
Unplug other appliances
Check that the mains voltage corresponds to the
specifications on the nameplate
Thermal sensor activated
Leave the machine to cool for 5 minutes
Partially blocked jet
Clean the jet with a needle and by spraying
water rearward through the jet
Fuse blown
Fuse too small
Replace it with a fuse with higher amp
consumption than the washer.
Increase in the amperage
Try without the extension cable
Pulsing machine
Air in inlet hose / pump
Allow machine to run with open trigger until
regular working pressure resumes.
Inadequate supply of water
generated
Increase water pressure, check for blockages
and / or change the large pipe.
Partially blocked jet
Clean the jet with a needle and then spray water
backwards through the jet
Water filter blocked
Clean the filter
Folded pipe
Unfold the pipe
The machine turns on
and off by itself
Pump fuse and/or trigger out of
order
Contact your nearest service center
No water supply
Connect the inflow water.
The machine is on
but no water comes
out
Water filter blocked
Clean the filter
Blocked jet
Clean the jet with a needle and by spraying
water rearward through the jet
7. Troubleshooting