Need help?Do you have a question about the Quooker Cold Water Filter and is the answer not in the manual?
General| Brand | Quooker |
|---|---|
| Model | Cold Water Filter |
| Category | Water Filtration Systems |
| Language | English |
Ensure bracket is positioned at least 2 inches from sink underside and 10 inches from cabinet base.
Secure the bracket at a selected location using one screw and mount the Cold Water Filter bracket.
Fixate the installed bracket firmly using the two remaining screws for the Cold Water Filter.
Connect the T-valve to the cold water supply using a hose screen, then reconnect the tap supply hose.
Push plastic tube (A) into the 'IN' inlet and plastic tube (B) into the 'OUT' outlet on the bracket.
Disconnect the tap hose from the top of the tank using size 10 and 14 spanners.
Connect T-piece to tank with washer, then connect tap hose to T-piece with another washer.
Secure the T-piece by correctly placing and fastening the locking clip.
Connect the Cold Water Filter by plugging the LED cable into the second jack-plug port.
Remove the yellow plug from the water filter cartridge before installation.
Screw the cartridge into place by turning anticlockwise until it stops; do not overtighten.
Open the T-valve by turning the blue handle in line with the plastic tube.
Run water through the cartridge for 5 minutes before use; expect black water initially.
To Next Page
