Need help?Do you have a question about the Quooker AC+HF and is the answer not in the manual?
General| Brand | Quooker |
|---|---|
| Model | AC+HF |
| Category | Water Filtration Systems |
| Language | English |
Position the bracket at least 2 inches/5 cm from sink underside and 10 inches/25 cm from cabinet base.
Install one screw at the selected location and mount the bracket.
Secure the bracket with the two remaining screws.
Connect the shut-off valve to the cold water supply using the provided hose screen and reconnect the supply hose.
Connect the blue striped hose to the bracket inlet ('IN') and the plastic hose to the outlet ('OUT').
Disconnect the tap hose from the top of the tank using size 12 and 14 spanners.
Connect the T-joint to the tank, then connect the plastic hose and tap hose using a red fibre washer.
Secure the plastic hose to the T-joint using the locking clip.
Connect the Cold Water Filter by plugging the LED cable into the second jack-plug port on the tank.
Remove the red cap from the Cold Water Filter cartridge before installation.
Screw the cartridge into the filter housing clockwise until it stops, but do not overtighten.
Turn the red knob of the shut-off valve anticlockwise to open it.
Run water through the filter for two minutes to remove carbon residue before first use.
To Next Page
