Quooker AC+HF User Manual

1 2
B
1. Connecting the shut-o valve
Shutothemainwatersupply.
Disconnectthecoldwatersupplyhose
fromthetap.Connecttheshut-ovalve
to a 3/8” male connection on the cold
watersupply(orincaseofaPRO3tank,
theinletreducingvalve)usingthehose
screenprovided.Reconnectthecold
watersupplyhosefromthetaptothe
shut-ovalveusingtheothersupplied
hose screen. When installing the Cold
WaterFilterwithaNordicsingletap,
screwtheblankingcapontothemale
threadoftheshut-ovalve.Connectthe
bluestripedhose(A)totheshut-ovalve
usingthebluebrewasher.
2. Connecting the bracket
Pushthebluestripedhose(A)rmlyinto
theinletmarked“IN”onthebracket.Push
theplastichose(B)rmlyintotheoutlet
marked“OUT”onthebracket.
Please note
Installthehoseswithouttensionand
sharpbends.Usethesuppliedelbow
connectorifnecessary.
Connecting water
- WhenfittingtheColdWaterFiltertoanexistingQuookersystem,switchofftheQuooker
 systembypressingthe‘Q’buttonontopofthetank.Leavethepluginthesocket.
- Runtheboilingandcoldwatertogetheruntilthewaterrunscold.
- Closethemainstopcockorisolationvalve(s).
- CheckiftheQuookersystemisdepressurizedbyopeningtheboiling-watertap.
 Nomorewatershouldnowcomeoutofthetap.
- Removetheplugfromthesocket.
- Whenconnectingthehoses,onlyusethesuppliedfibrewasherandhosescreens.Donotuse
and liquid sealants.
A
Cold water supply
IN OUT
AB
AB
IN OUT

Quooker AC+HF Specifications

General

Brand	Quooker
Model	AC+HF
Category	Water Filtration Systems
Language	English