5 Commissioning
5.1 Connect the POS System to the Power Supply
Risk of death due to electric current
Improper commissioning and use of the POS system can result in electric shocks. People could be seriously
or fatally injured.
Only connect the device to a socket with a grounded protective conductor.
Before connecting the device make sure that the voltage of your main power net corresponds to the
input voltage of your device.
Never connect or disconnect the power plug with wet hands.
Risk of injury from falling POS system
The setting up of the POS system on uneven surface can cause the POS system to fall. People could be
injured.
Place the POS system on a firm, stable, horizontal surface.
Risk of damage due to improper commissioning and use
The POS system and external devices can be damaged by improper use.
Switch off the device before connecting any peripheral devices.
Procedure:
1. Connect the power cord to the power adapter.
2. Connect the power adapter to the POS system.
3. Connect the POS system to the electrical outlet.
4. Remove the protective film of the touchscreen.
The POS system is properly connected to the power supply.
5.2 Install Receipt Roll
Risk of cuts due to Printer-Cutter
When installing the receipt roll, injuries to the hands can occur.
Before installing the receipt roll, switch off the POS system.
Procedure:
1. Push down the printer release lever (A)
to unlock the printer cover.
2. Open the printer cover and flip it
backwards. (B).
To Next Page
Loading...
Need help?
General
