R.M. Young 05103V - User Manual

METEOROLOGICAL INSTRUMENTS
INSTRUCTIONS
R.M. YOUNG COMPANY 2801 AERO PARK DRIVE, TRAVERSE CITY, MICHIGAN 49686, USA
TEL: (231) 946-3980 FAX: (231) 946-4772 WEB: www.youngusa.com
P/N: 05103V-90
REV: J111215
WIND MONITOR
WITH VOLTAGE OUTPUTS
MODEL 05103V

Summary

Introduction

Initial Check-Out

Check for shipping damage, install propeller facing forward, and verify free rotation.

Installation

Calibration

Calibration Formulas

Formulas for converting sensor signals (RPM, mV) to engineering units (m/s, knots, mph).

Maintenance

Potentiometer Replacement

Steps to replace a worn potentiometer due to noisy or non-linear signals.

Flange Bearing Replacement

Vertical Shaft Bearing Replacement

EMC Compliance

Warranty

CE Compliance

Cable & Wiring Diagram

Circuit Diagram

Bearing Replacement & Potentiometer Adjustment

General Assembly & Replacement Parts

R.M. Young 05103V Specifications

Model 18802 Anemometer Drive

Operating Range

range	200 to 15, 000 RPM in 100 RPM increments
rotation	Clockwise or Counter-Clockwise

Display

display resolution	1 RPM
quartz timebase reference	0.1 RPM

Power

power requirement	2x9 V (alkaline or lithium) batteries
AC wall adapter	115 VAC (230 VAC – add suffix H)

Model 18811 Anemometer Drive

Operating Range

range	20 to 990 RPM in 10 RPM increments

Display

display resolution	0.1 RPM

Model 18112, 18212 Vane Angle Calibration Devices

Operating Range

range	0 to 360 degrees

Display

resolution	0.5 degree

Model 18310, 18312 Torque Disc Devices

Operating Range

range	0 to 5.4 gm-cm

Display

resolution	0.1 gm-cm

Model 18331 Vane Torque Gauge

Operating Range

range	0 to 50 gm-cm

Display

resolution	5 gm-cm