RAB Lighting future flood

To Next Page

FUTURE FLOOD INSTALLATION INSTRUCTIONS

Thank you for buying RAB lighting xtures. Our goal is to design the best quality products to get the job done right. We’d like to hear your comments.

Call the Marketing Department at 888-RAB-1000 or email: marketing@rabweb.com

LIGHT

FIXTURE

(+)LINE BLACK

(-)COMMON WHITE

GROUND GROUND

LOCATION

1. Secure the Future Flood to any 1/2” NPS hole in a metal

plate coverplate, junction box or landscape post. Plug all

unused holes and seal threads with silicone.

2. The swivel arm on the Future Flood allows 150º of vertical

aiming adjustment.

3. Do not aim xture to any object closer than 18 inches.

LAMP INSTALLATION

CAUTION: Prior to installing, check that the lamp is

the correct ANSI type and wattage. Observe lamp

manufacturer’s recommendations on lamp operation,

ballast type and burning positions.

1. Disconnect power. Make sure xture and lamp are cool

enough to touch.

2. Remove screw from the door clip on the top of the xture.

Open xture, swing door down on hinges.

3. Fully insert lamp into socket.

4. Before closing door, make sure frame gasket is properly

seated all around the xture.

5. Close door. Replace screw on door clip, if desired.

WIRING

Do not use any supply voltage other than those specied

below:

FF35-FF150 HPS 120V only

FFH50-70 MH 120V only

FF42QT 120V thru 277V*

* No internal wiring changes needed for various voltages as

the ballast is quad tap electronic.

1. Connect the black xture lead to the (+) LINE supply lead.

2. Connect the white xture lead to the (-) COMMON

supply lead.

3. Connect the bare copper Ground wire from xture to

supply ground.

CLEANING & MAINTENANCE

CAUTION: Be sure xture temperature is cool enough

to touch. Do not clean or maintain while xture is

energized.

1. Clean glass lens with non-abrasive glass cleaning solution.

2. As lamps age, light output diminishes. Mass relamping at

regular intervals ensures full light output at the highest

eciency.

IMPORTANT

READ CAREFULLY BEFORE INSTALLING FIXTURE. RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE.

Fixtures must be wired in accordance with the National Electrical Code and all applicable local codes. Proper grounding is required

for safety. THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE BY A PERSON

FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED.

WARNING: Make certain power is OFF before installing or maintaining xture. No user serviceable parts inside.

Need help?

Do you have a question about the RAB Lighting future flood and is the answer not in the manual?

Summary

Important Safety Information

Electrical Code Compliance and Qualified Installation

Installers must comply with NEC, local codes, and be qualified for product installation and hazards.

Power Safety Warning

Always turn off power before installation or maintenance. The fixture contains no user-serviceable parts.

Lamp Installation Procedure

Lamp Compatibility and Guidelines

Verify lamp ANSI type and wattage, and follow manufacturer's recommendations for operation.

Power Off and Cooling

Ensure power is disconnected and the fixture and lamp are cool before proceeding.

Gasket Seating

Wiring Instructions

Voltage Specifications

Only use supply voltages specified for the fixture model to ensure correct operation and safety.

Connect Line Lead

Connect the black fixture lead to the (+) LINE supply lead.

Connect Common Lead

Connect Ground Wire

Replacement Parts and Troubleshooting

Troubleshooting Common Issues