Specifications:
Switching Capacity 8 amps
1000 watts Incandescent and 250 watts
Fluorescent
Voltage: 120 volts
Protection Pattern: 180° forward
360° below and to all sides
Time Adjustment: 5 seconds to 12 minutes
Power Consumption: 1 watt
Surge protection: 6000 volts
Cautions:
TURN OFF ALL POWER AT CIRCUIT BREAKER / FUSE PANEL.
■
Read entire Installation Manual before proceeding.
■
All wiring should comply with local electrical codes
and requires a qualified electrician.
■
The total lighting load connected to STL360 must not
exceed (1000 watts incandescent or quartz, 250 watts
fluorescent). To switch more wattage an electrician can
install a relay.
■
Line Carrier Remote Control Systems such as X-10,
Leviton or Radio Shack are incompatible with sensors and
may cause false activations.
■
Do not install sensors on a circuit that feeds motor
loads such as kitchen appliances, HVAC equipment,
washer/dryer, or garage door openers.
■
Sensor functions best when the direction of expected
movement is across its detection pattern, not towards
the sensor.
■
Mount 6’-12' high for optimum range and detection.
The STEALTH360 is the
most reliable and technically
advanced motion-activated light
control ever produced. This techni-
cal manual is written for electrical
professionals who wish to maximize
the performance and reliability of this
superb sensor.
RAB welcomes your questions
or comments.
Please call 888 722-1000,
or email tech@rabweb.com.
Thank you for purchasing a RAB
sensor.
STL360H
STL360HBW
STL360Q1
STL360Q3W
STL360Q2W
Installation Manual
To Next Page
Need help?
General
