RAB Lighting WPLED 10

To Next Page

WPLED 10W INSTALLATION INSTRUCTIONS

Thank you for buying RAB lighting  xtures. Our goal is to design the best quality products to get the job done right. We’d like to hear your comments.

Call the Marketing Department at 888-RAB-1000 or email: marketing@rabweb.com

Junction Box Surface Mount

IMPORTANT

READ CAREFULLY BEFORE INSTALLING FIXTURE. RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE.

Fixtures must be wired in accordance with the National Electrical Code and all applicable local codes. Proper grounding is required

for safety. THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE BY A PERSON

FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED.

WARNING: Make certain power is OFF before installing or maintaining  xture. No user serviceable parts inside.

CAUTION: For proper weatherproof function all gaskets must be seated properly and all screws inserted and tightened

 rmly. Apply weatherproof silicone sealant around the edge of the Back Box and/or Junction Box. This is especially

important with an uneven wall surface. Silicone all plugs and unused conduit entries.

JUNCTION BOX MOUNT FOR

CONDUIT

For use on applications where conduit wiring is necessary.

1. Loosen and remove (3) Lens Screws. Remove Door.

2. Loosen and remove (2) Housing Screws. Remove

Housing from Back Box. Keep Housing Gasket intact

for re-assembly.

3. Secure Back Box to the mounting surface using

hardware appropriate for that mounting surface.

4. Wire the  xture using UL listed wire connectors

according to NEC and local codes. Apply sealant to all

unused conduit entry points.

5. Place Gasket between Back Box and Housing.

Re-mount Housing to Back Box. Check Housing Gasket

seal all around the Back Box.

6. Re-mount Door to Housing. Tighten (3) Lens Screws.

Check door gasket (not shown) seal.

7. Fixture can be mounted as an uplight.

Lens Screws

SURFACE MOUNT FOR RECESSED

BOX

For use with recessed junction box and wiring.

1. Use supplied Crossbar. Mount Crossbar to Recessed

Junction Box with (2) screws.

2. Place Gasket on back of the  xture. Gasket should create

seal against mounting surface.

3. Wire  xture to supply wires in Recessed Box according

to wiring section.

4. Use 1/4 x 20 stainless steel Mounting Screw to attach

 xture to Crossbar. Tighten Mounting Screw.

5. Cover screw with Cap, provided.

6. Fixture can be mounted as an uplight.

Crossbar

Gasket

Mounting

Screw

Cap

Back Box

Housing

Gasket

Housing

Door

Housing

Screws

Recessed Junction Box

(not provided)

Need help?

Do you have a question about the RAB Lighting WPLED 10 and is the answer not in the manual?

Summary

Junction Box Mount for Conduit

Conduit Mount Installation Procedure

Detailed steps for mounting the fixture using a junction box and conduit wiring, including securing the back box and housing.

Surface Mount for Recessed Box

Recessed Box Mount Installation Procedure

Steps for mounting the fixture to a recessed junction box, including crossbar attachment and gasket placement.

Photocell Installation

Photocell Field Installation Guide

Instructions for installing a photocell in the field, including wiring connections and sealant application.

On-Off Wiring

Wiring for ON-OFF Operation

Guidance on connecting fixture leads for ON-OFF switching, specifying line, common, and ground connections.

Cleaning & Maintenance

Fixture Cleaning and Maintenance

Recommendations for cleaning the fixture lens and avoiding contact with the LED during maintenance.

Troubleshooting

Troubleshooting Steps

Common troubleshooting checks for voltage, grounding, and photocell functionality.