To Next PageTo Next Page
Need help?Do you have a question about the RAB Lighting HSLED Series and is the answer not in the manual?
Seal arm thread with teflon tape or sealant for weatherproof seal.
Connect fixture wires as shown in the wiring diagram for proper function.
Secure the fixture cover to the junction box on the wall surface.
Direct the floodlight and secure it by tightening the locknut and arm screw.
Ensure the weep hole is positioned to prevent water accumulation.
Screw the fixture into the Mighty Post Cap for mounting.
Wire the fixture as shown and place wires inside the Mighty Post.
Position the Mighty Post Cap onto the Mighty Post.
Adjust floodlight direction and tighten locknut and arm screw.
Ensure the weep hole prevents water accumulation in the hood.
Connect the black fixture wire to the (+) LINE supply lead.
Connect the white fixture wire to the (-) COMMON supply lead.
Connect the fixture's ground wire to the supply ground.
Check that the line voltage at the fixture is correct.
Ensure voltage is present at fixture wires; check connections if not.
Verify that the fixture is grounded properly.
If applicable, check if the photocell is working correctly.
Use non-abrasive cleaner on lens and fixture when cool and off.
Avoid opening the fixture to clean the LED or touching the LED.
Keep leaves and debris out of the fixture's hood.
Seal arm thread with teflon tape or sealant for weatherproof seal.
Connect fixture wires as shown in the wiring diagram for proper function.
Secure the fixture cover to the junction box on the wall surface.
Direct the floodlight and secure it by tightening the locknut and arm screw.
Ensure the weep hole is positioned to prevent water accumulation.
Screw the fixture into the Mighty Post Cap for mounting.
Wire the fixture as shown and place wires inside the Mighty Post.
Position the Mighty Post Cap onto the Mighty Post.
Adjust floodlight direction and tighten locknut and arm screw.
Ensure the weep hole prevents water accumulation in the hood.
Connect the black fixture wire to the (+) LINE supply lead.
Connect the white fixture wire to the (-) COMMON supply lead.
Connect the fixture's ground wire to the supply ground.
Check that the line voltage at the fixture is correct.
Ensure voltage is present at fixture wires; check connections if not.
Verify that the fixture is grounded properly.
If applicable, check if the photocell is working correctly.
Use non-abrasive cleaner on lens and fixture when cool and off.
Avoid opening the fixture to clean the LED or touching the LED.
Keep leaves and debris out of the fixture's hood.
General| Housing Material | Die-cast aluminum |
|---|---|
| Lens | Polycarbonate |
| Type | LED |
| Listings | UL, DLC |
| Color Temperature | 5000K |
| Input Voltage | 120-277V |
| Category | Outdoor Light |
