STL360HBW
STL360H
Manual
The STEALTH360 is the
most reliable and technically
advanced motion-activated light
control ever produced. This techni-
cal manual is written for electrical
professionals who wish to maximize
the performance and reliability of this
superb sersor.
RAB welcomes your questions
or comments.
Please call 888 72-1000,
or email tech@rabveb.com.
Thank you for purchasing a RAB
STL360Q1
STL360Q3W
Specifications:
Switching Capacity
Voltage:
Protection pattern:
Time Adjustment:
Power Consumption:
Surge protection:
UL USUSTED
c
Cautions:
8 amps
1000 watts Incandescent and 250 watts
Fluoresceit
120 volts
1800 forward
3600 below and to all skies
5 seconds to 12 minutes
1 watt
6000 volts
TURN OFF ALL POA,E-R AT CIRCU[T BREA}C-R / PANEL
• Read entire Installation Manual before proceeding.
• All wiring should comply with local electrical codes
and requires a qualified electrician.
• The total lighting load connected to STL360 must not
exceed (1000 watts incandescent or quartz, 250 watts
fluorescent). To switch more wattage an electrician can
install a relay.
• Line Carrier Remote Control Systems such as X-I O,
Leviton or Radio Shack are incompatible with sensors and
may cause false activations.
Do not install sensors on a circuit that feeds motor
loads such as kitchen appliances, HVAC equipment,
washer/dryer, or garage door openers.
• Sensor functions best when the direction of expected
movement is across its detection pattern, not towards
the sensor.
Mount 6'-12' high for optimum range and detection.
To Next Page
Need help?
General
