Rabbit Air BioGS 2.0 - User Manual

Complete these steps first before operating the unit.
Let’s Begin!
Quick Start Guide
Start Here
Next Page
Visit us at www.rabbitair.com
For questions, call 888.866.8862
24/7 customer care
BioGS 2.0 initial filter installation
Pre-Filter
BioGS HEPA
Filter
Charcoal-Based
Activated Carbon
Filter
Front panel
1. Remove the front
panel by lifting from the
bottom and pulling up.
2. Pinch the two tabs on
top of the Pre-Filter to
remove it.
4. Remove the HEPA Filter and
discard its plastic wrapping.
3. Pull out the Activated Carbon Filter
and discard its plastic wrapping.

Summary

Initial Filter Installation Steps

Remove Front Panel

Lift the front panel from the bottom and pull it up to remove it from the unit.

Remove Pre-Filter

Pinch the two tabs on top of the Pre-Filter to remove it.

Remove Activated Carbon Filter

Pull out the Activated Carbon Filter and discard its plastic wrapping.

Remove HEPA Filter

Remove the HEPA Filter and discard its plastic wrapping.

Finalizing Filter Installation

Reassemble Air Purifier

Return filters in order and reattach the front panel to complete assembly.

Understanding the User Interface

Device Control and Settings

Control power, modes, fan speed, timer, and air quality indicators.

Filter Status Indicators

Monitor filter maintenance and replacement status via dedicated indicators.

Rabbit Air BioGS 2.0 Specifications

General

Model	BioGS 2.0
Type	Air Purifier
Filter Stages	4
Pre-Filter	Washable Pre-Filter
Coverage Area	625 sq ft
Filter Type	HEPA
Odor Filter	Yes
CADR (Dust)	200
CADR (Pollen)	200