RacerMate CompuTrainer - Software Configuration and Testing; Calibration Settings and Grade Configuration; Loading and Setting Up Software; Course Creation and Test Execution


Step5(cont):Youwantareadingbetween 2.00‐2.20lbsof
pressure.PressF3onthecontrolboxtosetthis.Nowplugthe
PCUSBcablebackintoPC,labelledEXTPC.Thescreenwillnow
sayPRO.
FlatCourse‐use2lbs†Press‐OnForce
Upto2.5%Grade‐use2.5lbs
†Press‐OnForce
Upto5.0%Grade‐Use3.0lbs
†ofPress‐OnForce
Upto7.5%Grade‐Use3.5lbs
†ofPress‐OnForce
Upto10.0%Grade‐Use4.0lbs
†ofPress‐OnForce
Upto12.5%Grade‐Use4.5lbs
†ofPress‐OnForce
Upto15.0%Grade‐Use4.99lbs
†ofPress‐OnForce*
†Plus/minus.20lbsacceptable.
*5.0lbsexceedsthemaximumvalueyoucansave.

Step6:LoaduptheCompuTrainer3Dso ftware (desktop
shortcut)
Step7:Select‘SetupOptions’,thenselecttheoptionstab(top
rightofscreen),selecttheparametersyouwantdisplayedon
thescreen(e.g.speed,watts,RPM,distanceetc).Atthebottom
ofthisboxselect‘New’toadd
asubject,thenpress‘OK’
Step8:Clickontheroadsegmentstocreateacourse(left,right
andstraight)keepclickingtoaddasmanyasyourequire.You
canalsoalterthelengthofthesegmentstospeedupthe
process.Makesureyouadda‘Finish’at
theendofthecourse
(bottomleftofthescreen)
Step9:TostartthetestpressF1onthecontrolboxanda3,2,1
Gocountdownwillshowonscreen
Step10:Attheendofthetesta boxwillappearsaying‘Save
Rider1Performa nce’,
selectYes.Anotherboxwillappearafter
this,selectYesagain.
Step11:MinimiseCompuTrainer3DandopenCompuTrainerCS
1.6onthedesktop.SelectFile–Export–Export.Selectthe
subjectwhotestedandclickopen.
