RacerMate CompuTrainer

To Next Page



CompuTrainerUserGuide

Step1:Connectallthecablesupbeforeswitching itonatthe

socket.(THISISVITALASITMAYCAUSETHECONTROLBOXTO

SHORTOUTANDBREAK)

Step2:ConnecttheUSBtothePCportonthefrontwhilstthe

PCisstillturnedoff

Step3

:MakesuretheCompuTrainerunitswitchissettotheoff

positionbeforeturningonatthewallsocketandpoweronthe

PC

Step4:Warmupthecomputerwhilstpoweredonbycyclingfor

5‐10minutesatadecentpace

Step5:OncetheCompuTraineris

warmedup,itwillneedtobe

calibrated.(IMPORTANT:MakesurethePCcableisUNPLUGGED

fromthecontrolbox)Onthecontrolbox(theyello wandblack

boxwithbuttonson)itwilldisplay0.00.Tocalibrate,simply

pedaluptoapproximately25mphonthedisplay,thisshould

take

about5‐6revolutionsofthepedalsifyoutrytosprintand

stoppedallingoncethedisplaystopssaying‘UP’.Waitforthe

backwheeltoslowdownto0mph.Ifitfailstoreachthe

requiredlevels(below),usetheadjustmentscrewonthe

CompuTrainerbythebackwheel

totighten/loosen.Itisavery

fineadjustmentsosmalladjustments.

Youwantareadin

between2.00‐2.20lbsof

ressure.PressF3

Other manuals for RacerMate CompuTrainer

Quick Start Guide2 pages

Need help?

Do you have a question about the RacerMate CompuTrainer and is the answer not in the manual?

Summary

CompuTrainer Initial Setup and Calibration

Connection and Power On

Connect all cables before powering on, ensuring the unit switch is off. Connect USB to PC while PC is off.

Warm-up Procedure

Warm up the CompuTrainer unit by cycling for 5-10 minutes at a decent pace.

Calibration Process

Calibrate the warmed-up unit by pedaling to 25mph and stopping when prompted. Adjust screw if needed.

Software Configuration and Testing

Calibration Settings and Grade Configuration

Set calibration pressure (2.00-2.20lbs) using F3, then connect PC cable. Configure grade settings for various conditions.

Loading and Setting Up Software

Load CompuTrainer 3D software, select display parameters, and add a new subject.

Course Creation and Test Execution

Create a course by adding road segments and a finish line. Start the test using F1 for countdown.

Saving and Exporting Performance Data

Save rider performance data from CompuTrainer 3D and export it to a file.

Data Viewing and Analysis

Accessing Data in Wordpad

Open Wordpad, then navigate to the exported performance files to view the data.