Verbatim Autodialer Specifications
Verbatim Owner's Manual I-7
I.22 Additional Features: Sealed Switches,
LED Indicators, Alarm Disable Warning,
TalkThrough
All keyboard and front panel switches shall be sealed to prevent contamination.
Front panel LED’s shall indicate: Normal Operation, Program Mode, Phone
Call in Progress, Status for each channel, AC Power Present, AC Power Failure,
and Low, Discharging or Recharging Battery. On any Inquiry telephone call or
On Site status check, the voice shall provide specific warning if no dialout
phone numbers are entered, or if the unit is in the “alarm disable” mode, or if
AC power is off or has been off since last reset. A built-in microphone shall
allow anyone at a remote phone to listen to local sounds and have a two-way
conversation with personnel at the dialer.
I.23 Special Order Items
The following options shall be available on specific order:
a) 4, 12, 20, or 28 extra contact channels (8,16,24, or 32 respectively, total.)
b) 32, 64, 96 remote channels
c) 1, 4, 8, or 16 analog channels.
d) Remote supervisory control (4 or 8 outputs).
e) Cellular telephone communications.
f) Radio communications interface.
g) NEMA 4X (sealed) enclosure.
h) Thermostatically controlled heater.
Specifications subject to change without notice.
To Next Page
Loading...
