Advanced Programming
Verbatim Owner's Manual
6-15
! Note:
DN is the 2-digit Designation Number: 01 for the first phone number, 02 for
the second number, up to 16 for the 16th phone number.
Refer to Programming Worksheet A. Write down each phone number you
wish to program, along with a person’s name, for future reference.
u To program the first phone number to be dialed on alarm, press:
7 01 (then the complete phone number) ENTER.
u To program the second phone number to be dialed on alarm:
Use code 7 02 in place of 7 01, progressing to a maximum of code 7 16
for a 16th phone number.
Each phone number may be up to 60 digits in length. Be sure to include any
necessary area codes or “1” prefixes.
u To erase phone number DN, press:
7 DN POINT ENTER.
u If you need Touch Tone dialing, press:
9 01 1 ENTER.
u For high speed dialing, press:
9 01 2 ENTER.
I Caution:
"High speed dialing" may not work reliably with some older telephone
company exchanges.
u To switch back to pulse dialing, press:
9 01 0 ENTER
u To insert delays between dialed digits (e.g. after a leading “9” in PBX
systems), in the programming process, press the MINUS key once for
each one-second delay desired. To extend the length of each delay beyond
1 second, press:
9 28 N ENTER
where N is the number of seconds of delay desired for each delay invoked
with the MINUS key.
To Next Page
Loading...
