Advanced Programming
Verbatim Owner's Manual
6-25
Once established, whenever you press a Command Tone 1 at the prompting
beep, the unit first prompts you to enter the Access Code before allowing you to
perform programming or message recording operations. You may still read
existing programming without using the Access Code by pressing a Command
Tone 2 at the prompting beep. However, the Access Code itself cannot be read
over the phone.
u To delete the Security Access Code so that no code is required in order to
perform over the phone programming, press:
9 1 0 POINT ENTER (at the panel) ONLY
(921, 930) Power Failure Alarm Function ON/OFF;
DISARM/RE-ARM All Alarms
u To turn off the Power Failure Alarm function, press:
9 21 0 ENTER
u To turn the Power Failure Alarm function on again, press:
9 21 1 ENTER
u To disarm the unit, preventing any alarm call outs, press:
9 30 0 ENTER
u To rearm the unit, press:
9 30 1 ENTER
At the front panel, the same result is more easily obtained by using the
DISARM/RE-ARM key.
(700, 924) Callback/Callforward
This feature causes the unit to dial a special “zeroth” phone number on com-
mand. This is typically initiated over the phone, causing the unit to call back to
the person who invoked the command, in order to verify the ability of the unit
to successfully dial out. The unit gives a status report of all channels as part of
this call.
u To program this special callback number, press:
7 00 (then the complete phone number) ENTER
u To initiate the actual dialing, press:
9 2 4 ENTER
If you have executed this command over the phone, the unit will advise you that
it will be calling the callback number in 15 seconds. Then it will end the current
call in preparation for placing the callback call. If you have executed this com-
mand at the front panel, the dialing will occur immediately.
To Next Page
Loading...
