Advanced Programming
6-26
Verbatim Owner's Manual
Note:
If the Verbatim autodialer is in the disarmed mode,
call-outs/autocalls will not be made.
(926) Delay Before Return to Normal (Exit Delay)
Sometimes it is desirable to prepare the unit for the ability to detect violations
and dial out, but with an “exit delay” that allows the user time to exit or remove
temporarily existing alarm violations before the unit becomes active.
To set delay before Return to Normal:
1. Press:
9 26 V ENTER
where V is the desired delay in minutes (range 1.0 to 99.9 minutes).
2. Then press DISARM/RE-ARM if necessary to extinguish the flashing
DISARMED legend light. However, do not press NORMAL, but instead
leave the unit in PROGRAM mode, with the PROGRAM light illumi-
nated. The unit cannot go into alarm while in PROGRAM mode.
When the delay period times out, the unit will automatically return to NOR-
MAL mode and will then be ready to act on any alarm violations that occur
after that time. This code must be re-entered each time you wish an exit delay,
since the delay value automatically returns to the default value of 2 minutes
upon timeout.
The 2 minute default value provides protection against the possibility that
someone might walk away leaving the unit in PROGRAM mode, or perhaps
hang up the phone after performing over-the-phone programming without
properly ending the call.
(932, 933, 934) Microphone and Speaker Operation
If you enable the front panel microphone using program code 933 as described
below, the microphone will be automatically activated for a 15 second listening
period at the end of each alarm or inquiry call, allowing you to hear the sounds
near the unit from a remote telephone.
An additional warble tone is issued at the end of this listening period, allowing
you to postpone tone acknowledgment until after the listening period.
u To turn this function on, press:
9 33 1 ENTER
u To turn this function off, press:
9 33 0 ENTER
To Next Page
Loading...
