rada Meynell V8/3 User Manual

3
If you experience any difculty with the installation or operation of your new Mixing
Valve, then please refer to “Fault Diagnosis”, before contacting Kohler Mira Ltd.
Our telephone and fax numbers can be found on the back cover of this guide.
INTRODUCTION
The Meynell V8/3 is a Thermostatic Mixing Valve specied to meet the highest
standards of safety, and reliability as demanded by today’s users. All Meynell products
are designed, manufactured and supported in accordance with accredited BS EN
ISO 9001: 2000 Quality Systems.
This Manual covers all Meynell V8/3 Thermostatic Mixing Valves manufactured from
June 1997.
The sufx ‘3’ indicates that this mixer has been certied for use in UK Healthcare
premises as a Type 3 valve under the BUILDCERT TMV3 scheme. For Healthcare
installation refer to the TMV3 Requirements Manual.
The approved designations for Type 3 Valves are as follows:
Meynell V8/3 Model Designation.
Description Installation
Temperature
Adjustment
Finish
Meynell V8/3 Exposed or Built-In
Short Lever
Adjustable
Chrome
Meynell V8/3 L Exposed or Built-In
Long Lever
Adjustable
Chrome
Meynell V8/3 K Exposed or Built-In Locked Chrome
Model Designations
Rada Meynell V8/3 HP-S, HP-W, LP-S, LP-W
Important! The tting of any ow regulator will invalidate TMV3 compliance due to
the minimum ow rate requirements. Do not t ow regulators in TMV3 applications.

rada Meynell V8/3 Specifications

General

Brand	rada
Model	Meynell V8/3
Category	Control Unit
Language	English