Need help?Do you have a question about the rada DRV40 and is the answer not in the manual?
General| Brand | rada |
|---|---|
| Model | DRV40 |
| Category | Control Unit |
| Language | English |
Provides general instructions for installation by qualified personnel.
Illustrates the plumbing layout and explains schematic symbols.
Explains how to adjust temperature via PC software and USB.
Input and set the adjusted setpoint temperature for the DRV40.
Adjust Max, Min, and Default setpoint values for the DRV40.
Critical warnings about high temperatures and process hazards.
Activates disinfection via 'Trigger' and provides 'Abort' for emergency stop.
Procedure for calibrating the valve after replacing parts.
Critical safety warnings and initial steps for disassembly.
Provides detailed steps for disassembling the DRV40 unit.
Guides on removing the front cover and accessing internal parts.
Details the process of removing screws and components from the module.
Guides on connecting cables and securing the PCB with screws.
Provides initial steps for disassembling the DRV unit and removing the casing.
Details removing components from the main valve body.
Guides on removing screws from the valve body.
Details the correct fitting of seals for the DRV unit.
Uses a hex screw to assist cartridge removal, with caution.
Guides on refitting the cartridge and removing the assistance screw.
Displays a warning about calibration and prompts for confirmation.
Proceeds with calibration and waits for the DRV40 to reset.
Lists and explains specific error messages displayed by the DRV40.
Addresses common problems and their potential causes.
Explains errors related to emergency mode, PCB, motor, and thermistor failures.
Explains 'Error Temp', battery, display readability, and power errors.
Addresses fluctuating temperatures and suggests mechanism checks.
To Next Page
