9
DEFAULT SETTINGS
The following table shows the factory default settings of the Rada DRV40. These
values can be altered using the 'DRV Programming Software' available to install
from the USB stick supplied.
Temperatures
Adjusted Setpoint 49 °C
Setpoints
Max 68 °C
Default 49 °C
Min 38 °C
Alerts & Valve Units
Valve Units °C
Above Setpoint 2 °C
Below Setpoint 2 °C
Error Temp 60 °C
Activate Relay on Alert On
Disinfection
Enable Disinfection Off
Disinfection Timeout 1 minute
Options
Valve Address null
Network Modbus Inactive
Modbus Address (when 'Active') 3
To Next Page
Loading...
