27
Thermal Disinfection
IMPORTANT! PLEASE READ CAREFULLY
The thermal disinfection mode of the DRV40 is not an automated process. It is
manually activated by the supervisor to increase the temperature of the blend circuit
to equal the temperature of the hot supply. The circuit pipework and outlets can be
thermally disinfected regularly as part of good bacterial infection control.
DO NOT USE THE THERMAL DISINFECTION FEATURE
IF THE HOT WATER SUPPLY CAN EXCEED 80°C!
Warning! Thermal disinfection is a potentially hazardous process
to raise the water temperature to a level that will scald or even
kill. It is therefore the responsibility of the person supervising
the process to make sure it is carried out correctly and safely.
ALL DRV40 DISPLAY ALERTS AND ERRORS
ARE DISABLED DURING THE PROCESS!
continued...
To Next Page
Loading...
Need help?
General
