x)
TEMPO
and other settings can be changed as desired.
xi) In
case
any more thekas are to be programmed, repeat
the entire process
from
step (ii) above. Select one of the
other 3 keys in step (iii) if more than one theka is to be
programmed
into
the instrument
without
erasing the
previously programmed theka.
6.0 HELPFUL
HINTS
6.1 If on pressing the
START
key, the theka is not heard, press
STOP
key again and restart.
6.2 If, during operation, the theka stops due to sudden power
fluctuation or temporary loss of power, press
STOP
key and
then restart.
6.3 Any operation of any knob can be performed
without
stopping the theka.
6.4 Operation of the taal selection keys and the laya selection
keys
must be preceded by stopping of the theka, if not
already stopped.
6.5 It is recommended
that
the condition of the batteries is
checked
once in two weeks to avoid leakage of chemicals
and consequent damage to the instrument.
6.6 The "Taalmala" is a very reliable and rugged instrument.
Failure
of components is rare. No damage can be done to
it by pressing the keys in the wrong order. At the most, the
desired theka may not be achieved. Correct usage of
controls
will
then immediately ensure the desired effect.
8.0 WARRANTY
The "Taalmala" is guaranteed against manufacturing
defects for a period of one year
from
the date of
sale.
Warranty is valid only if the
seal
on the instrument is intact
and if the completely filled-in counterfoil of the warranty card
is
received by the manufacturer
within
15 days of
sale.
The "TAALMALA" is a
maestro
at
your
command.
We
wish
you
many
fruitful
years
of
music
with
its
accompaniment.
Note:
Due to continuous
efforts
at
Improvement
and
further
innovation,
the
manufacturers
reserve
the
right
to
make
changes in design and
performance
of
the
instrument
at
their
discretion.
ADDENDUM
On
instruments provided
with
a detachable AC mains
cord,
the instrument would operate on batteries if the
cord is detached
from
the socket at the rear of the
instrument.
7.0
SERVICING
AND REPAIRS
Normally no periodic servicing is required. Should any
problem arise, it is advisable to contact the dealor or
manufacturer for advice and repairs. Servicing by untrained
technicians is likely to permanently damage the instrument.
Radel Electronics Pvt. Ltd.
147.
12th
Cross,
J.P. Nagar, 2nd
Phase
Sar-ga*xe
560 078 India Tel. : 6637438
Satos
& Service - Tel. : 6647991
To Previous Page
Loading...