PAGE 9
Setting AutoCity Speed GPS Lockouts
settings.
The AutoCity driving mode allows the
setting of minimum alert detection speed
for signal suppression and signal filtering
resulting in significantly reduced false alerts.
Select AutoCity in setting mode.
Setting AutoCity speed (this feature is only
selectable if the Pro M is in AutoCity mode):
tapping the middle button lets you select
the speed for editing.
The left speed setting indicates the speed
below which the radar reception of the
detector will be disabled. No signals from
police radar or false signals will be reported.
The recommended setting is 20 mph.
The right speed setting indicates the speed
below which the detector will detect alerts
in City mode with reduced radar sensitivity.
The recommended setting is 35 mph.
The + / - buttons on the right side of the
detector will change the specific setting.
Setting the City and AutoCity sensitivity
(this feature is only selectable if the Pro M is
in City or AutoCity mode): by means of the
middle button you can select the radar band
for editing.
To change the sensitivity of signal reception
use the +/- button on the right side of the
unit. The level of signal suppression can be
selected between 0-9. The display numbers
indicate the sensitivity reduction in the
different radar bands.
The detector lets you mark known false
alert areas so that you will not receive audio
alerts in the future at the marked location.
The detector stores the GPS coordinates and
radar band, frequency, and signal strength
and compares it each time the signal is
received. If the received signal at the
lockout location differs from the saved signal
in terms of frequency or signal strength, the
detector automatically unmutes and you will
be alerted by audio again.
The display will show the band and signal
strength and a small “L” icon in front of the
radar band letter indicates that the area is
locked out. You can either ignore the alert or
delete the saved lockout.
To set a GPS lockout press the middle
button during an alert for two seconds. The
detector will state “lockout started” and will
complete the process by stating “false alert
area added.”
To manually remove lockout from the
detector, press the middle button for 2
seconds in a locked out area. You can also
delete all lockouts in the menu.
To Next Page
Loading...