®
5
BLUETOOTH PAIRING
Once the BT-Pro is connected to a power supply, a blue LED on the
top of the unit will illuminate. At this point you can turn the RESET/
ON switch to the ON position, and the BT-Pro will be available to pair
with Bluetooth devices. Check the available devices on your Bluetooth
enabled playback source; the BT-Pro should appear in the list as ‘Radial
Eng’. Once you select the BT-Pro, your plackback device should prompt
you for a password. The password is 1246. Once initially paired, the BT-
Pro automatically converts the streaming audio to analog for connection
to a variety of systems. Your device should automatically reconnect on
future sessions, as your smartphone does in your car.
1. Make sure the BT-Pro volume control is
turned fully counter clockwise.
2. Enable Bluetooth pairing on your
Bluetooth enabled device.
3. Connect your BT-Pro to power, a blue
LED on the top of the unit will indicate
that it is receiving power.
4. Turn on the BT-Pro to enable Bluetooth
pairing.
5. Blue and red LED’s will alternate
showing the BT-Pro is in search mode
for pairing.
6. Your Bluetooth device will identify the
BT-Pro as ‘Radial Eng’ in the Bluetooth
devices menu.
7. Select the BT-Pro in your Bluetooth
devices menu.
8. Your Bluetooth device will then ask for
a rst time password for the BT-Pro.
Type in: 1246.
9. Once your Bluetooth device has paired
with the BT-Pro, the blue LED will ash
once every three seconds. When audio
is playing, the blue LED will ash three
times quickly every three seconds.
Once your Bluetooth device has been paired to the BT-Pro, the BT-Pro
will automatically pair to the same Bluetooth device when the BT-Pro is
turned back on in range.
To Next Page
Loading...
Need help?
General
