20
7. Troubleshooting
If the device does not start:
•Make sure that the power cord is connected into the wall electrical outlet�
•Check the fuse inside the fuse drawer� Replace fuse if blown (see instructions on
Fuse Replacment section)�
•If a pulse sequence is not released when pressing the Pulse Switch:
•Gently press the Handpiece opening onto the skin and listen for the audio signal�
If there is no audio signal, contact FSD Plus service center�
•The device might be overheated� Turn off the device for 30 minutes to allow it to
cool down�
•If the pulse rate within a sequence slows down or if the charging and ready indicators
turn on and off repeatedly, the device may be overheated� Turn off the device for 30
minutes to allow it to cool down�
•If at any point the device goes into charging mode for longer periods, this is due to
an internal safety mechanism that monitors the LUA temperature and is designed to
avoid over-heating� Wait until the ready indicator light turns on again, and only then
replace the handpiece on the skin�
•If any problem persists, contact FSD Plus service through Radiancy or your point of
purchase�
Radiancy is responsible for the effects on safety, reliability and performance of the
equipment only if repairs are carried out by Radiancy authorized personnel�
To Next Page
Loading...