P1550 User Guide
Version .9
10 4/12/05
Wedge Mount Installation
Setting Up the P1220
In order to begin using the P1220 for your POS operations, you must first set up various standard and peripheral
components, including connecting the power source, connecting the P1220 to your network, and connecting any
necessary peripheral devices. This section outlines these setup processes.
Note: After all connections have been made, always close the CableStrap™ System to secure the
cables and prevent accidental disconnects.
CableStrap™ System
The CableStrap™ System is an innovative feature on the P1220 that provides for ease of installation, controlled
access to connectors, concealed cable routing, and cable restraint for better reliability.
Note: After all connections have been made, always close the CableStrap™ System to secure the cables and
prevent accidental disconnects.
1. Tilt touch head back
2. Open CableStrap™ System
3. Plug cables in the input/output connectors
4. Route cables in cable strap and secure strap
5. Tilt unit to user operating position
To Next Page
Loading...
Need help?
General
