What to do if my Radiant RS 30 E Boiler has no water in the system?
If there's no water in your Radiant Boiler system, it could be due to insufficient water pressure (stops at 0.3 bar), in which case you should fill the system. Alternatively, the water pressure switch cable might be disconnected (check the wiring), or the water pressure switch could be malfunctioning (replace part).
What does it mean if the safety thermostat tripped (95 °C) in my Radiant RS 30 E Boiler?
If the safety thermostat tripped (95 °C) in your Radiant Boiler, it could be due to thermostat malfunction or being out of calibration, so replace the part. It also could be because the thermostat cable is disconnected, so check the wiring.
How to troubleshoot a heating sensor issue in a Radiant RS 30 E?
To troubleshoot a heating sensor issue in your Radiant Boiler, consider these potential causes: the sensor may be malfunctioning or out of calibration (resistance value 10 kOhms at 25 °C), in which case you should replace the part. Alternatively, the sensor cable may be disconnected or wet, so check the electrical connection.
What causes the air pressure switch problem in my Radiant RS 30 E?
The air pressure switch problem in your Radiant Boiler can be caused by several factors. The switch might be out of order, requiring a replacement. The inlet or outlet flue gas ducts could be obstructed, so check the flue gas ducts. Also, the switch cable might not be stable, so check the cable.
How to fix a parameter programming request issue in my Radiant Boiler?
A parameter programming request issue in your Radiant Boiler is caused by a loss of microprocessor memory. To resolve this, reprogram the parameters.
To Next Page
General
