USER INSTRUCTIONS
3
3. Starting up the boiler
• Check that the boiler is power supplied and that the gas feed valve, placed at the bottom of the boiler, is
open.
• Switch on the boiler by using MODE SELECTION BUTTON and select the functioning mode
required.
4. INFO Menu
Press the ‘ ’ INFO Button to display the boiler data.
Once pressed, the parameter number will appear on the left side of the display and the associated
parameter value will appear on the centre of the display. Use ‘ ’ and ‘ ’ buttons of Heating
Temperature setting to scroll the list of available data.
Press the ‘ ’ INFO button to exit the display mode.
The list of available display data is the following:
Parameter
d00
D.H.W temperature sensor
d01
Outdoor temperature sensor
d02 Kd Thermoregulation value
d03
Low temperature circuit sensor (only with Zone PCB connected)
To Next Page
Loading...
Need help?
General
