46
47
Charging the Hand Controller
3 41 2
Connect the power cable to the power
supply. Then put the Hand controller on
the charger as shown in the image.
When the Hand controller is being char-
ged one or several LEDs will ash depen-
ding on the state of charge. It may take
up to two minutes before the Hand con-
troller indicates charging and LEDs starts
to lit.
When the LEDs turn off, the hand
controller is fully charged.
To test the state of charge of the Hand
controller, gently press the throttle lever
until the LEDs start ashing. The number
of LEDs ashing indicates the state of
charge of the Hand controller.
BOARD PREPARATIONS BOARD PREPARATIONS
To Next Page
Loading...