Radio Shack 1400214 - Setting the Recorder; Set Recording Quality; Set Recording Sensitivity

6
Setting the Recorder
Press and hold MODE until SE
E
appears. In this mode, you can
perform the following actions.
Set Recording Quality
1. If necessary, press PLAY repeatedly
until SP, MP, HP appear.
2. Press RWD or FFWD to select your
voice recording mode: SP, MP, HP (the selected option
fl ashes), then press PLAY to confi rm your selection.
For recording through a microphone:
Recording Mode Recording Quality Max. Recording Time
SP (standard play) Good 262 hours
MP (medium play) Very good 136 hours
HP (high play) Best quality possible 92 hours
3. Proceed to set recording sensitivity, or press MODE to exit
setting mode.
n Note:
• You must play a recorded message to check its recording mode.
• The backlight turns on when you press a button and shuts
off after 30 seconds.
Set Recording Sensitivity
1. Press PLAY repeatedly until mic:HI appears.
2. Press RWD or FFWD to switch between HI and Lo, then
press PLAY to confi rm your selection.
3. Proceed to set SD or SDHC card (not
included), or press MODE to exit.
n Note: Select Lo when the sound
source is close. Otherwise, select HI.