Radio Shack 15-316 - Operating the Selector Switch; Using the Remote Control; Manual Operation; Remote Control Battery Replacement

6
2 Use the Selector Switch
Using the remote control to operate the selector switch
1. Press1-4 ontheremotetoviewthedeviceconnectedto
INPUT 1-4.
2. Operatethedeviceasusual.
Manually operating the selector switch
1. PressSELECT onthefrontpaneltoviewthedevice
connectedtoINPUT 1-4,insequence.
2. Operatethedeviceasusual.
Replacing the Battery in the Remote Control
Yourremotecomeswithabatteryinstalled.Removetheplastic
tabbeforeusingtheremote.Replacethebatteryiftheremote
controlstopsoperatingproperly.
1. Pressthetabonthebatterycompartmenttray,slidethe
batterycompartmenttrayout.
2. Insertanew3V,CR2025battery,
positive“+”sideup.
3. Slidethetraybackintothebattery
compartmentuntilitclicks.
b Battery Notes:
• Keepbutton-cellbatteryawayfromchildren.Swallowinga
button-cell battery can be fatal.
• Disposeofbatteriespromptlyandproperly.Donotburnor
bury them.
• Useonlyfreshbatteriesoftherequiredsizeandtype.