Radio Shack 2100989 - Select Location; Install Antenna

3
1 Select Location
1. Selectaconvenientatsurfacelocationfortheantenna
base.Makesuretheantenna:
• doesnotblockthedriver’sview.
• doesnotinterferewithwindshieldwiperoperation.
2. Cleanthesurfacetoremovedirt.
2 Install Antenna
1. Screwtheloadingcoilsectionoftheantennaontothe
threadofthemountingmagnetbase.
2. Placethemagnetbaseontoyourcar.
3. Routethecoaxcableintothecar,preferablythrougha
window.
Ifroutedthroughthetrunkoradooropening,tapethe
cablesecurelytothedoorframeusingacloth-backedtape.
Cablewillnormallynotbeharmedbyopeningandclosing
thewindow,door,ortrunk.
Ensurethatthecableisnotcrushedordeformed.
4. RunthecabletoyourCBtransceiverandconnectthe
coaxplugtothetransceiverantennaconnector(seeyour
transceiver’sinstructions).
n Notes:
• Do not remove the foil covering the bottom of the
magnet structure. The foil protects car finish and
makes a good “capacitive” ground.
• DO NOT SHORTEN THE COAX CABLE as it is the
proper length set for peak performance.