6
The Basics
setting up your mixer
installing batteries
Your can power the mixer with a 9-volt battery (not supplied).
1. Remove the battery
compartment cover.
2. Insert the battery.
3. Replace the cover.
Replace the battery when
BATTERY LOW lights.
using AC power
Your can power your mixer with a 9V AC adapter (not supplied).
The recommended AC adapter supplies nine volts of power and
delivers 300 milliamps. Its plug properly fits the mixer’s DC 9V jack
and its center tip is set to negative (–). Using an adapter that does
not meet these specifications could damage the mixer or adapter.
Insert the AC adapter’s barrel plug into the mixer’s
DC 9V jack.
Plug
the AC adapter’s other end into a standard AC outlet.
Always connect the AC adapter to the mixer before you connect
it to AC power. When you finish, disconnect the adapter from AC
power before you disconnect it from the mixer.
DC 9V
To Next Page
Loading...