Radio Shack 4-Channel Stereo Microphone Mixer - Four Microphones; Outputs

9
The Basics
four microphones
Connect up to four microphones to the mixer’s MIC jacks (1-4). Each
microphone signal is routed to the mixer’s corresponding channel.
If you connect an audio device and a microphone so they are
output to the same channel, the signals from both devices are
mixed and controlled by the mixer’s corresponding channel
control. For example, if you connect a microphone to MIC 1 and a
CD player to AUX 1 L and R, signals from the microphone and CD
player are routed to CHANNEL 1.
outputs
To play the mixer’s output through your speaker system (at parties,
dances, conferences), use an audio patch cord (not supplied) to
connect the mixer’s OUTPUT L and R jacks to your receiver/amplifier’s
line input jacks.
To record the mixer’s output, use an audio patch cord to connect
the mixer’s OUTPUT L and R jacks to your tape deck’s line input jacks.
MIC jacks