5
Connect the Speakers
1. Place the subwoofer on a fl at surface. Place the two
satellite speakers as far as possible from each other.
2. Connect the plug of the satellite speakers to the
subwoofer’s To Speaker jack.
3. Turn oNj your audio source, then connect the Control
Pod’s plug to your audio source.
4. Plug the power cord into a wall outlet.
n Note: To connect the Control Pod’s plug to your source
device, you may need a 3.5mm stereo Y-type cable (not
included).
Use Your Speakers
1. Turn on your audio source.
2. On the Control Pod, slide ON/OFF to ON.
3. Rotate the Volume Control
(on the top of the Control Pod) to
adjust to a comfortable listening
level, and rotate the Bass Vol
control (on the back of the
subwoofer) to desired bass tone.
ON/OFF
To Next Page
Loading...
