19
Remote Operation
tone, enter your remote operation security code. Enter a remote
command (see “Remote Commands” on Page 19). When you
finish, press
5#
to end remote access.
REMOTE COMMANDS
Note:
When listening to messages in remote mode, there is a
pause during playback every 2 minutes and 40 seconds. Press
0
–
9
,
#
, or
∗
∗∗
∗
to continue playing the message.
LIGHTNING
Your system has built-in protection circuits to reduce the risk of
damage from surges in phone line or power line current. These
protection circuits meet or exceed FCC requirements. However,
lightning striking the phone line can damage your system.
Press To
1#
Play new messages.
2#
Play all messages.
3#
Delete the current message.
4#
Repeat a previous message.
5#
Stop and exit.
6#
Skip a message.
7#
Turn on/off the system.
8#
Record an outgoing message.
9#
Record a memo.
0#
Monitor the room.
To Next Page
Loading...