2. Press ▼ four times until [VOL LOCK] appears.
NOTE:Ifyou go past [VOL LOCK],press ▲ one or more times to
return to it.
3. Press SELECT once to begin programming. [TO MODE]
appears.
4. Press a mode key (e.g., AUDIO) to lock a device’s volume con-
trols to all modes. [SUCCESS] and then [EXIT SETUP] appear
as the remote control automatically exits the programming
mode and returns to normal operation.
5. If desired, repeat steps 1 through 4 as needed to lock volume
controls for other devices to all modes.
Programming Volume Unlock
1. On the remote, press and hold P until the display changes
from the default device and time to [CODE SET].
2. Press
▼ five times until [VOL UNLOCK] appears.
NOTE:Ifyou go past [VOL UNLOCK],press ▲ one or more times to
return to it.
3. Press SELECT once to begin programming. [ALL MODE]
appears.
To unlock one mode, skip to step 4. Otherwise press SELECT
once to unlock all modes.[UNLOCKED] and then [EXIT
SETUP] appear as the remote automatically exits the
programming mode and returns to normal operation.
4. (Optional) Press
▲ (or ▼) once.[ONE MODE] appears.
a. Press SELECT once. [SEL MODE] appears.
b. Press a mode key once (e.g., TV) to unlock it. [UNLOCKED]
and then [SEL MODE] appear.
c. If desired,repeat step 4b as needed to unlock volume
controls for other devices. Otherwise, press EXIT to exit the
programming mode.An [EXIT SETUP] message appears as
the remote returns to normal operation.
USING MACROS
With Macro programming, your remote can be setup to perform repeti-
tive,time-consuming operations for easy, convenient access through the
press of a single key. Macros are ideal for home theater operations,setting
a favorite channel,guide steps,or other multiple functions you would like
to control with one key press. Moreover, each macro can hold up to 15 key
presses total.
NOTE: Programming a new macro over an existing one will erase the original macro.
PROGRAMMING A FAVORITE CHANNEL
With so many channels available through your cable or satellite system
provider, you can program a macro that directly selects a favorite channel
with one key press. For example, let’s assume your favorite cable programs
are on channel 71. Perform the following steps to program a macro for
direct access of this channel:
NOTE: This example assumes the TV connects directly to the cable and not through
a cable converter.
1. On the remote, press and hold P until the display changes
from the default device and time to [CODE SET].
NOTE: Default values for device, its code, and time are shown
above.Your remote control settings may be different.
NOTE: If you wish to exit the programming mode at any time, press
EXIT once. An [EXIT] message appears as the remote control returns
to normal operation.
NOTE:Ifan [INVALID] message appears, you have inadvertently
pressed an incorrect key. Simply note your error and continue
programming.
2. Press ▼ six times until [KEY MACRO] appears.
NOTE:Ifyou go past [KEY MACRO],press ▲ one or more times to
return to it.
continued on next page...
USER’S
GUIDE
Changing Volume Lock/Using Macros 13
(x 5)
(x 6)
(x 4)
or
To Next Page
Loading...
