Radio Shack Passive - Replacing Remote Battery

25
Care
REPLACING THE REMOTE
CONTROL’S BATTERY
Your sensor alarm’s remote control uses the supplied
12V alkaline battery for power. When the remote con-
trol’s indicator lights dimly or not at all when you press
ARM
or
DISARM
, or if the remote control stops operat-
ing properly (the main unit cannot receive the remote
control’s signals), replace the battery. We recom-
mend you replace it with an alkaline battery (available
at your local RadioShack store).
Cautions:
Use only a fresh battery of the required
size and recommended type.
Follow these steps to replace the battery.
1. Using a Phillips screwdriver, remove the screw
from the back of the remote control, then lift off
the back case.
2. Remove the old battery, then place a fresh bat-
tery inside the back cover, as indicated by the
polarity symbols (+ and –) marked inside.
3. Be sure the small loop on one end of the key-
chain fits over the post inside the back cover,
then replace the cover. Reinsert and tighten the
screw.
49-329.fm Page 25 Thursday, June 1, 2000 7:46 AM