If you set a search range that crosses over into a range of
frequencies that the scanner cannot tune, the scanner searches
only up to the limit of tunable frequencies and returns to
the starting frequency.
SCANNING THE CHANNELS
To begin scanning channels or to start scanning again after monitoring
a specific channel, press SCAN.
The scanner scans through all channels (except those you have locked
out) in the active banks).
NOTES: You must store frequencies into channels before the scanner can
scan them.
The scanner does not scan empty channels.
To change the scanning direction, press UP ARROW or DOWN ARROW.
TURNING CHANNEL-STORAGE BANKS OFF AND ON
To turn off banks while scanning, press the bank's number key until the
bar under the bank's number disappears. The scanner does not scan any
of the channels within the banks you have turned off.
NOTES: You cannot turn off all banks. There must be at least one
active bank.
You can manually select any channel in a bank, even if the bank is
turned off.
To turn on banks while scanning, press the bank's number key until a bar
under the bank's number disappears. The scanner does not scan any of the
channels within the banks you have turned off.
NOTES: You cannot turn off all banks. There must be at least one active
bank.
You can manually select any channel in a bank, even if the bank is
turned off.
To turn on banks while scanning, press the bank's number key until a bar
appears under the bank's number.
MOVING FREQUENCIES
Moving a Frequency from a Monitor Memory to a Channel
1. Press PROGRAM.
2. Use the number keys to enter the channel number where you want to
store the monitor frequency, then press PROGRAM again.
3. Press MONITOR and enter the desired monitor mem ory's number (1-40),
then press MONITOR again. The selected monitor memory's frequency
appears.
To Next Page
Loading...
