Radio Shack PRO-2041 - Reviewing Locked-Out Channels;Frequencies; Priority Feature

the frequency, then continues searching.
NOTES: The scanner does not store locked -out frequencies during a search.
If you try to lock out more than 200 frequencies, L -FULL appears.
Follow these steps to remove the lock -out from a frequency.
1. Press BAND or LIMIT or DIRECT/.to start a search .
2. Press L/OUT REVIEW. L-r appears.
3. Repeatedly press UP ARROW or DOWN ARROW until the frequency you want
to remove the lockout from appears.
4. Press L/OUT. The frequency you want to remove the lockout from
disappears.
If there is another locked-out frequency, it appears. If there are
no more locked-out frequencies, the scanner continues searching.
Reviewing Locked-Out Channels/Frequencies
To review the channels you locked out, press MANUAL, then repeatedly
press L/OUT REVIEW. As you press L/OUT REVIEW, the scanner displays
all locked-out channels.
To review the frequencies you locked out, press BAND, LIMIT, or DIRECT/.
to start a search, then press L/OUT REVIEW. L/OUT REVIEW L/r appears.
As you press UP ARROW or DOWN ARROW, the scanner displays all locked -out
frequencies.
USING THE PRIORITY FEATURE
The priority feature lets you scan channels and still not miss important
or interesting calls on the priority channels. You can program up to 10
frequencies as the priority channels. When you turn on the priority
feature, as the scanner scans channels. It checks one of the priority
channels every 2 seconds for activity.
NOTE: You can lock out priority channels. If you lock out all priority
channels, the scanner displays PCH ALL -OFF when you lock out the
last channel.
Follow these steps to store frequencies in the priority channels.
1. Press PROGRAM.
2. Use the number keys to enter the priority channel number (1 -10)
where you want to store the frequency, then press PRIORITY.
3. Use the number keys to enter the frequency you want to store into
that channel.
4. Press ENTER to store the frequency.
NOTES: If you entered an invalid frequency in Step 3, the scanner
beeps and displays Error. Simply repeat Steps 3 and 4.