Radio Shack Speaker - Speaker Mounting and Power; Connecting AC Power; Mounting the Speakers

5
Connecting AC Power
1. Insert the supplied 12V, 1800mA AC
adapter’s barrel plug into the
DC 12V
jack located at the back of the speaker.
2. Plug the other end of the AC Adapter
into an AC wall outlet.
3. Route the adapter’s cord through the
strain relief slot on the back of the
speaker.
Repeat the above steps for the other speaker.
Mounting the Speakers
To mount a speaker on the wall, you need a
screw (not supplied) with a head that fits
into the keyhole slot on the back of the
speaker.
1. Select a location and drill a hole at the
location.
2. Thread a screw into the hole until the
screw’s head extends about 15mm from
the wall.
3. Align the keyhole on the speaker with
the screw head in the wall, then slide
the speaker downward to secure it.