General Information
Loading TRSDOS
See
the
Operation Manual for instructions on connection, power-up
and
inserting
the
System diskette.
Note: A System diskette must be in Drive 0 (the built-in unit) whenever the
Computer
is in use. Whenever the
Computer
is
turned on
or
reset, it will
automatically load
TRSDOS from Drive
O.
After
the
System starts up, it will prompt you to
enter
the date. Type in the
date
in
MMjDDjYYYY
form
and
press 13m*I .
For
example:
07/04/1979
for July 4, 1979.
Next
the
Systemwill prompt you to
enter
the time.
To
skip this question, press
.
The
time will start at 00:00:00.
To set the time, type
in
the
time
in
HH.MM.SS 24-hour form. Periods are
used instead
of
colons since they're
easier to
type in. The seconds
are
op-
tional. For example:
14.30
for 2:30 pm.
The System will record
the
time and
date internally and return with the
message:
TRSDOS
READY
53
To Next Page
Loading...
