Radio Shack TRS-80 PC-3

Figure 28.
(6) Type:
CLOAD (SHIFT) "PRO-1 (SHIFT) "
and press the (ENTER) key.
(Remember "PRO-1" is the filename we have given to your program. If you saved the program under another name, you
must use that name instead of PRO-1.)
(7)
The "BUSY" indicator will now light up, and the program will be brought back into the Computer's memory for use.
(8)
The cassette retains a copy of the program, so you can CLOAD the same program over and over again!
If an error message (ERROR 8) is displayed while loading, start again from the above step (1).
Precautions for collation and transfer
The program is recorded on tape as illustrated below:
+-- Tape transport direction
JL..--' -l_Non-Signal_~-1 ~.
I section (Beep) j i I ~---- Program ~
Filename
When the tape is played back, its non-signal section produces a specific continuous beep, while the filename and program-
recorded sections cause an intermittent beep.
93