Appendix
B
Initializing with
HARDGEN's
Option
D
(Head-by-Head
Procedure
This
append^
describes
the way to use Option D of the allocation
menu
of
The HARDGEN program. Before
attempting
to use this
option
,
you should be familiar with the TRSDOS 6
operating
system
and Us
initialization procedures. >fbu
should also
have
analysed
your system requirements.
The
major purpose
ol Option
D
is to
allow programmers to con-
figure
a
TRSDOS 6
hard disk system to their requirements
when
no
other HARDGEN option enables them to do so.
Option D produces a
JCL
file that
performs
the
initialisation,
It
also
produces a
small
file thai provides
an
audit
trail
of
the
system con-
figuration
on
initialization.
Option does not check on the
suitability
of
every
data
Hem that
you
enter. It is
up
to you lo determine that everything is in order
before going en to ihe initialization.
Two sample uses
of Option
D are
given
at I he
end
of
the
appendix
.
Follow Steps 1 through 8 of the
HARDGEN
program.
At
Step S,
choose
Option
D;
then
follow
ihe
steps
below:
ft HARDGEN prompts you with a
warning,
to prevent the
accidental
use
of
Option D, followed by the question:
Are you sure you wish to continue
<Yes or No>
If you
are prepared
to
continue,
type V
CEBft*Ei$ and continue
to yiep 18
below,
it not, type N
LEMIEED,
and HARDGEN
returns
to
Step
&
1G, HARDGEN
displays another
warning, Press
the space
bar
to
continue. The program asks you to detine the type
of
physical
device to which each of the S possible logical drives is to be
assigned.
43
To Next Page
Loading...
