EasyManuals Logo

RadioMaster TX16S Manual

RadioMaster TX16S
3 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
OriginHobbies_OMP_M1_M2_TX16S_RTF_OMP_v1.1
OMP M1/M2 TX16S RTF configuration
[OMP Protocol]
Thank you for choosing OriginHobbies as your dealer for OMPHobby and Radiomaster products.
We have carefully prepared the RTF model configuration for you so you can start flying your
helicopter as easily as possible. We still recommend that you carefully read this guide so that you
are confident to make your first flight. If you have any questions please do not hesitate to contact
us. Best wishes!
Batteries (setup and care):
Your TX16S Radio Transmitter is delivered with the LiPo battery unplugged for safety during
transportation. Open the battery case and connect the LiPo battery to the Radio Transmitter. Close
the battery case. Please fully charge the Radio Transmitter before first use.
The TX16S Radio Transmitter has 2 USB ports.
The USB port at the top is a data port for connecting to computer. (Simulator mode [HID] or
Data transfer mode [Mass storage])
The USB port at the bottom (under a pull up strip) is a charging port for charging the Radio
Transmitter battery.
For faster charging you can also charge the battery using an external balance charger. Please
disconnect the battery from Radio transmitter before connecting to an external charger.
Battery care tips:
The Helicopter LiPo batteries are shipped at storage charge (50%). Please fully charge the
helicopter battery before any flight. It is recommended to use a balance charger at 1C (max
2C if in a hurry).
Avoid quick charge programs. They will cause the cells to go out of balance with time.
Don’t leave battery charging process unattended. There is always risk of heating and fire so
you must be present nearby to take proper action if that happens.
Always use a flight timer depending on your flying style and ensure that battery is never
discharged less than 25% capacity. (about 3.73V per cell)
When not in use for prolonged periods, charge all LiPo batteries to storage charge (50%
charge 3.86V per cell).
Following these simple rules will ensure your batteries are in good health and you can have
many flights with them.
Page 1/3
© 2021 OriginHobbies.com

Other manuals for RadioMaster TX16S

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the RadioMaster TX16S and is the answer not in the manual?

RadioMaster TX16S Specifications

General IconGeneral
Channels16
Operating SystemOpenTX
MCUSTM32F429
Screen Resolution480 x 272 pixels
Touch PanelNo
Radio Frequency2.4GHz
RF ChipCC2500, NRF24L01, A7105, CYRF6936
Antenna Gain2dBi
Voltage Range6.5V - 8.4V
Simulator SupportYes
SD Card SlotYes
BluetoothNo
SpeakerYes
VibrationYes
BacklightYes
Display4.3 inch color display
Battery2 x 18650 or 2S LiPo
GimbalsHall sensor gimbals
RF ModuleInternal multi-protocol module
USB PortUSB-C
Transmitting Power100mW (max)
RangeUp to 2km
Upgrade MethodUSB, SD card
ChargingUSB-C charging
RF ProtocolsMultiprotocol (FrSky, FlySky, DSMX, etc.)
External Module BayJR-style module bay

Related product manuals