Need help?Do you have a question about the RadioMaster TX16S and is the answer not in the manual?
General| Channels | 16 |
|---|---|
| Operating System | OpenTX |
| MCU | STM32F429 |
| Screen Resolution | 480 x 272 pixels |
| Touch Panel | No |
| Radio Frequency | 2.4GHz |
| RF Chip | CC2500, NRF24L01, A7105, CYRF6936 |
| Antenna Gain | 2dBi |
| Voltage Range | 6.5V - 8.4V |
| Simulator Support | Yes |
| SD Card Slot | Yes |
| Bluetooth | No |
| Speaker | Yes |
| Vibration | Yes |
| Backlight | Yes |
| Display | 4.3 inch color display |
| Battery | 2 x 18650 or 2S LiPo |
| Gimbals | Hall sensor gimbals |
| RF Module | Internal multi-protocol module |
| USB Port | USB-C |
| Transmitting Power | 100mW (max) |
| Range | Up to 2km |
| Upgrade Method | USB, SD card |
| Charging | USB-C charging |
| RF Protocols | Multiprotocol (FrSky, FlySky, DSMX, etc.) |
| External Module Bay | JR-style module bay |
Lists conditions under which the TX16S remote control system should not be operated.
Details battery compatibility and essential safety warnings for charging.
Guides users on downloading and installing the OpenTX Companion software.
Explains how to use the Companion software to update the TX16S firmware.
Guides on calibrating the battery voltage for accurate monitoring.
Provides step-by-step instructions for calibrating gimbals and controls.
Explains how to set the default gimbal mode and channel output order.
Guides on creating new models and selecting existing ones for use.
Details the extensive settings available within the Model Setup menu.
Explains how to set up and customize flight modes for different flying behaviors.
Guides on defining and configuring input sources for channels and controls.
Explains how to create and configure channel mixes for advanced control.
To Next Page
