53
-Use the switch to adjust the backlight brightness
In addition to a few of the commonly used methods listed above, the ever-
changing features allow you to realize your imagination
The three examples in the picture are represented as：
SF1
：
When the SF switch position is
↑
, the CH3 channel will be covered by -100.
Usually this setting is used to lock the throttle.
SF2：When the logic switch L01 is automatically turned on, lowbat (low battery
voltage) voice will be broadcasted. The rightmost 3s means that the voice will be
broadcasted every 3 seconds. Automatically turn on when
SF3：When the remote control is activated, the LS slider is defined as a function
to control the system volume
Each model can have 64 special functions. In addition, there are 64 global settings
that are common to all models. To use the global function, please enter the Global
Functions page in the remote control system settings to set it.
Each setting is activated with a trigger switch. You can select physical switches,
logical switches, fine-tuning buttons, and flight mode. There are two other special
options, ON and Ones (which are always enabled when the machine is turned on), and
One (which is performed only once when the machine is turned on)
Press and hold the ENT key to enter the sub-menu for displaying sources by
category. Scroll up or down to select the desired category and press the ENT key.
To Next Page
Loading...
