RADIOMETER TCM3 - Page 88

2. TCM3
Serial Output, Continued
TCM3 and TCM30 Service Manual
Category B
(continued)
AUX Program (XF Package)
Line ID. XF
Field ID: DM site timer display mode (X)
Trend indication (X)
pCO, temp. corr. (X)
Alarm volume (XX)
Analog
output
range,
pO,
(X)
TR
TC
MF . Metabolic factor (X) mmHg/(X.Y) kPa
AV
OR
CR | Analog output range, pCO, (X)
HT
Heat
at
site
timer
expiry
(X)
1 = site timer
2 = heating power
3 = temperature
0= off, 1=on
0= off, 1 = on
1=0-200 mmHg/0-25 kPa
2=0-800 mmHg/0-100 kPa
1=0-100 mmHg/0-10 kPa
2=0-200 mmHg/0-25 kPa
0= off
1= on
If
the
monitor
is
measuring
only
pO,
or
pCO,,
the
field
CR
or
OR
respectively
is
omitted.
The
fields
TC
and
MF
are
included
even
if
only
pO
is measured.
Miscellaneous (XX Package)
Line ID: XX
Field ID: PS
“Serial Input”
TCM3 state (XX). Refer to state diagram in the paragraph
AA Active alarms (XXXXXX) binary array (O= off, Ion)
active alarms in the following order: high pO», low pO», high
pCO,, low pCO,, site timer, temperature.
Pressure unit (0 or 1) =kPa, 1= mmHg
In-vivo calibration (0 = disabled, 1= enabled)
Electrode current (poO») at calibration (XXXX) рА
UP
VI
DS Main board DIP switch position (TCM3 run 1-21 only)
IE
VE
Electrode voltage (pCO:) at calibration (XXX.Y) mV
The fields IE and VE are not included during calibration before start of the
stability check. If the monitor is measuring only pO, or pCO) , the field VE or IE,
respectively, is omitted.
Continued on next page