Need help?Do you have a question about the RADIOMETER ABL800 FLEX and is the answer not in the manual?
General| Type | Blood Gas Analyzer |
|---|---|
| Weight | Approximately 45 kg |
| Power Requirements | 100-240 V AC, 50/60 Hz |
| Measurement Parameters | Blood gases, electrolytes, metabolites, CO-oximetry |
| Analytes Measured | pH, pCO2, pO2, Na+, K+, Ca++, Cl-, Glucose, Lactate |
| Sample Type | Whole blood, plasma, serum |
| Sample Volume | Minimum 65 microliters |
| Analysis Time | Approximately 60 seconds |
| Measurement Principles | Electrochemical (pH, pCO2, pO2, electrolytes), Amperometric (Glucose, Lactate), Photometric (co-oximetry) |
| Display | Color touchscreen |
| Connectivity | Ethernet, USB, RS232 |
| Power Supply | Internal |
| Data Storage | Up to 10, 000 samples |
| Data Management | LIS connectivity |
| Quality Control | Automatic QC, QC lockout feature |
Details on analyzer limitations and substances that interfere with measurements.
Explanation of the touch screen interface, sections, and elements.
Programs for managing operators, passwords, and access profiles.
Guidelines for mixing blood samples and handling capillary blood samples.
Procedures for single, batch, and urgent measurements using FLEXQ.
Procedures for preparing QUALICHECK+ and AutoCheck control solutions.
Steps for manual QC measurements and AutoCheck operation.
Procedures for calling unscheduled calibrations and handling interruptions.
Procedure for tHb calibration and interpretation of calibration results.
Procedures for replacing membranes, electrodes, and pump tubes.
Steps for backing up, restoring, and exporting data and archives.
Steps for temporarily shutting down and storing the analyzer.
Conditions causing forced hold and troubleshooting for inlet calibration.
Identifies potential errors in sample collection and handling.
Default settings for Analyzer Security, Analysis, Calibration, and QC.
To Next Page
